Replacing Fuel Pump In Ford Focus: Step-By-Step Guide

Replacing the fuel pump on a 2005 Ford Focus can be a complex task. It is important to first identify whether the fuel pump is faulty. Some symptoms of a failing fuel pump include a loss of engine power, an inability to start the car, or the check engine light coming on. If you are certain that the fuel pump needs to be replaced, it is recommended to get it repaired at a professional shop due to the risk of fire. The average cost for a Ford Focus Fuel Pump replacement is between $739 and $926. However, if you are confident in your auto repair skills, you can attempt to replace the fuel pump yourself. Be sure to have the necessary tools and safety precautions in place, such as working in a well-ventilated area and ensuring there are no open flames.

Disconnect the battery

Disconnecting the battery is the first step in changing the fuel pump on a 2005 Ford Focus. This is a crucial step to ensure safety and reduce the chance of a fire. Here is a detailed, step-by-step guide on how to disconnect the battery:

Step 1: Park your car on a level surface and engage the parking brake. This will prevent the car from moving during the process.

Step 2: Locate the battery. The battery in a 2005 Ford Focus is typically located in the engine compartment on the driver's side, near the fender.

Step 3: Identify the negative battery terminal. It is typically marked with a "-" symbol or a black cover.

Step 4: Prepare the necessary tools. You will need a wrench or socket set that fits the battery terminal.

Step 5: Loosen the nut or bolt securing the negative battery cable to the terminal. You may need to use some force to break the corrosion that has built up over time.

Step 6: Carefully remove the cable from the terminal. Be cautious not to let the cable touch any metal parts of the car, as this could cause a short circuit.

Step 7: Isolate the cable. Place the cable away from the battery and any metal components to avoid accidental contact. You can use a cable tie or tape to secure it in place.

By following these steps, you will have successfully disconnected the battery in your 2005 Ford Focus, ensuring a safer environment for your fuel pump replacement. Remember to exercise caution and wear appropriate protective gear when working with car batteries.

Remove the fuel pump fuse

To remove the fuel pump fuse on a 2005 Ford Focus, follow these steps:

First, locate the fuse box. It is likely under the hood, in the fuse/relay box, as this is where most of the vital engine fuses and relays are located. Check your owner's manual if you're unsure.

Once you've located the fuse box, open it and look for the fuel pump fuse. It should be a 15-amp (blue) fuse. On some models, it may be fuse #12.

After removing the fuse, start your engine and let it run until it dies. This will depressurize the fuel system.

Once the engine has stalled, you can proceed with replacing the fuel filter or performing other maintenance tasks. Remember to put the fuse back in before reconnecting the negative terminal and starting the car again.

Jack up the car

Jacking up your car is an essential step in replacing the fuel pump on your 05 Ford Focus. Here is a detailed, step-by-step guide on how to do it safely and effectively:

Before you begin, ensure you have a suitable jack and jack stands that can support the weight of your vehicle. Place the jack on level ground and refer to your car's manual to locate the recommended jacking points. These are the reinforced areas of the car's underbody designed to bear the weight of the vehicle when lifted.

Position the jack underneath the car, following the instructions in your manual. Engage the parking brake, and for added safety, place chocks or blocks behind the driving wheels to prevent accidental rolling.

Now, slowly raise the jack until it makes contact with the car's underbody and is securely positioned on the jacking point. Continue to raise the jack until the car is at a height that allows you to comfortably slide under the vehicle and access the fuel tank. This should be approximately two feet in the air, as described by one Focus owner who performed this procedure.

Once you have achieved the desired height, carefully place the jack stands in the appropriate positions as per your car's manual. Lower the vehicle onto the stands, ensuring they are securely in place and able to bear the weight of the vehicle. Double-check that the car is stable and cannot roll or shift before proceeding.

With the car securely raised and supported, you can now slide under the vehicle and begin the process of replacing the fuel pump. Remember to exercise caution when working underneath a raised vehicle, and only proceed if you are confident in your abilities and have taken the necessary safety precautions.

To recap, follow these crucial steps when jacking up your car:

• Identify the recommended jacking points in your car's manual and position the jack accordingly.
• Engage the parking brake and chock the driving wheels for added safety.
• Raise the jack until it makes contact with the jacking point, then continue until the car is approximately two feet off the ground.
• Position and place the jack stands securely according to the car's manual.
• Lower the vehicle onto the jack stands until it is stable and firmly supported.
• Double-check the stability of the vehicle before proceeding with the fuel pump replacement.

Remove the fuel filter

To remove the fuel filter on a 2005 Ford Focus, first disconnect the fuel filter from the fuel line. To do this, push in the plastic clip and give it a small tug. It is easier to disconnect one side because the other side is attached to the fuel tank and will come out when you drop the tank.

Once you have removed the fuel filter, you can proceed to lower the tank. It is best to have something or someone to help hold the tank up while you remove the straps. To do this, simply remove the 1/2 inch bolt that is located roughly above the fuel filter. Once this is loose, the front of the tank will drop down.

Now, you can finish pulling the tank by disconnecting the wire harness and two hoses from the back of the tank. This is where your flat-head screwdriver will come in handy. Loosen both clamps and pull the tank forward; the hoses will come right off.

Remove the fuel tank

To remove the fuel tank from a 2005 Ford Focus, you will need a flat-head screwdriver, a 5/32 or 3/16 socket with a 6-inch 1/4 drive extension, a hammer, shears, and a 1/2-inch socket.

Before you begin, ensure your fuel tank is below a quarter full. You will also want to get the car in the highest and safest position possible. Jack up the car and place a jack stand underneath it.

Start by removing the two metal nuts holding the heat shield in place. You can then either remove the others or cut along the crease with your shears so that it can fold down. Disconnect the fuel filter from the fuel line by pushing in the plastic clip and giving it a small tug. It is best to have someone help hold the tank up while you remove the straps. To do this, remove the 1/2-inch bolt located roughly above the fuel filter. Once this is loose, the front of the tank will drop down.

To finish pulling the tank, disconnect the wire harness and two hoses from the back of the tank. Loosen both clamps and pull the tank forward, and the hoses will come right off.

Frequently asked questions