Replacing The Fuel Pump In A 2000 Honda Civic Ex

If you're experiencing issues with your 2000 Honda Civic EX, you may need to replace the fuel pump. This is a relatively simple process that you can do yourself, but if you have any doubts, it's best to take your car to an auto shop. The fuel pump is located under the rear seats and is accessible by removing the back seat pan and the metal cover. You will need a Phillips screwdriver and a 10 mm ratchet wrench to remove the bolts holding the cover in place. Before beginning this process, ensure there are no sources of smoke nearby as you will be working near fuel.

Remove back seat

To remove the back seat of a 2000 Honda Civic EX, first locate the seatbelt brackets on the sides of the seat. You will need to remove the bolts holding these in place. Then, fold down the back of the seat and remove the fasteners at the bottom. There should be a bracket between the two rear seats with two screws that need to be removed. Finally, there is a single 10mm bolt in the back/middle of the bench seat that needs to be removed. Once all the bolts are removed, gently pull up on the seat until it pops out. Be careful not to damage the fuel sender wire located underneath the seat.

Remove pump cover

To remove the pump cover of your 2000 Honda Civic EX, you must first remove the back seats. Grab both ends of each seat firmly and pull upwards, wiggling it as you do so. Take the seats out of the car to avoid damaging them. There are small latches on the front edge of the seat that you can use to help with this process.

Once the seats are removed, locate the metal pump cover. Use a Phillips screwdriver to remove the four bolts holding the cover in place. Then, tilt the cover out of the way to gain more access to the fuel pump.

Disconnect pump

Disconnecting the fuel pump in a 2000 Honda Civic EX is a complex process and should only be performed by those with the necessary knowledge and experience. If you are unsure about any of the steps, it is recommended that you take your car to an auto shop.

Working near fuel can be dangerous, so it is important to ensure there are no sources of smoke nearby as this could lead to a fire or explosion.

To disconnect the pump, first remove the back seat of the car. This will give you access to the pump, which is located underneath. Once you have located the pump, you will need to remove the metal cover that is holding it in place. This is done by using a Phillips screwdriver to remove the four bolts. With the cover removed, you can now access the pump and the various components that need to be removed before it can be disconnected.

Start by slipping off the boot that covers the wiring connector and then unplugging the connector. Next, use pliers to remove the clamp on the rubber hose. Now you can disconnect the main fuel line by squeezing it. Finally, use a 10 mm socket and ratchet to unbolt the bracket holding the pump in place.

With these steps completed, the fuel pump in your 2000 Honda Civic EX will be successfully disconnected and ready for removal. Remember to have a drip pan nearby to catch any fuel that may drip from the fuel strainer during this process.

Remove strainer

To remove the strainer of your 1992-2000 Honda Civic, first make sure you have a drip pan handy, as the fuel strainer can drip fuel. Once you have the correct safety equipment, disconnect the top plug and remove the strainer clamp. The strainer should now be ready to be removed.

Install new pump

Now that you have removed the old pump, you are ready to install the new one.

Firstly, slide the new pump into place. Reconnect the plug and fuel strainer. Then, slide it back into the fuel tank opening. Bolt the bracket back in with the six screws to hold it in place.

Next, connect the fuel line and rubber hose. Plug the connector back in. Reattach the connector boot. Finally, reattach the access cover with the five bolts.

Now, you can re-install the backseat. Ensure that you have no sources of smoke nearby when working near fuel.

Frequently asked questions