Fuel Filter Change: Diy Guide For Your 240Sx

how to change fuel filter 240sx

The fuel filter in a Nissan 240SX should be replaced every 10,000-15,000 miles, or every 60,000 miles according to one forum user. The process of changing the fuel filter is relatively straightforward and can be done at home. It involves taking off the gas cap, removing the fuel pump fuse, loosening the clamp on the top hose, sliding the clamp up on the tube, and then repeating the process for the lower tube. It's important to be careful when removing the hoses to avoid spills and leaks. The whole process takes around 15-20 minutes if the tubing comes off easily.

shunfuel

Where is the fuel filter located?

The fuel filter on a Nissan 240SX is located on the passenger side of the engine bay, attached to the strut tower about halfway down. It is a cylindrical metal canister that sits vertically and has a hose connected to its top and bottom nozzle. The top hose leads to the fuel filter, and the bottom hose is connected to the fuel line.

To access the fuel filter, you will need to remove the gas cap and take out the fuel pump fuse in the fuse box, which is located by the battery. The engine will need to be cranked, and it should start and then immediately die.

The fuel filter can be challenging to remove due to the nipple-like plastic tubes coming off the filter, which can seize to the rubber fuel tubing over time as the tubing hardens. It is important to be careful when removing the tubing to avoid damage and leaks. Twisting the fuel filter while holding the tubing can help loosen the connection.

Once the fuel filter is removed, it is important to place a rag or towel underneath to absorb any spilled fuel.

shunfuel

How to remove the old fuel filter

To remove the old fuel filter from your Nissan 240SX, you will need to first release the fuel pressure. Do this by removing the gas cap and taking out the fuel pump fuse. You can find the fuel pump fuse in the fuse box by your battery, or by your left foot if you have an S14.

Next, crank the engine. It should start and then immediately die. Now you can start to remove the hoses from the fuel filter. Loosen the clamp on the top hose and slide the clamp up the tube, then tighten it slightly to squeeze the tube shut. This will prevent fuel from spilling out. Repeat this process for the lower hose.

Note that the hoses may be difficult to remove. The filters have nipple-like plastic tubes that can seize to the rubber fuel tubing, especially if the tubing has hardened over time. Twist the fuel filter while holding the tubing to help loosen the connection. Avoid pulling straight out, as this could result in cut knuckles or a sore elbow. Also, do not use pliers on the tubing, as this will damage them and cause a leak.

Once the hoses are off, some fuel may still spill out, so it is a good idea to place a rag or towel underneath the filter to absorb any spills. Now you can remove and discard the old fuel filter.

shunfuel

How to install the new fuel filter

To install a new fuel filter in your Nissan 240SX, you will need to first relieve the fuel pressure. Take off the gas cap and remove the fuel pump fuse in the fuse box by your battery. You should be able to locate it by checking the cover. With the fuse removed, crank the engine, and it should start and then immediately die.

Now, locate the fuel filter on the passenger side of the engine bay, attached to the strut tower about halfway down. It resembles a small silver canister with a hose going into the top and another coming out of the bottom. Loosen the clamp on the top hose, and then slide the clamp up the tube, squeezing the tube shut. Be careful not to tighten it too much, as you could rip the tubing. Repeat this process for the lower tube.

Removing the old filter can be challenging due to the plastic tubes coming off the filter that may seize to the rubber fuel tubing. Twisting the fuel filter while holding the tubing can help loosen the connection. Avoid pulling straight out, as this may result in injury, and do not use pliers on the tubing, as they can cause damage and leaks. Once the tubes are off, some fuel may spill out, so have a rag or towel ready to absorb it.

To install the new fuel filter, simply follow the above steps in reverse. Attach the hoses to the new filter, and then re-tighten the clamps to their original positions. Ensure that you do not over-tighten the clamps, as this can damage the tubing. Once the new filter is securely in place, you can replace any fuses you removed, put the gas cap back on, and prime the pump before starting your car.

shunfuel

How often should the fuel filter be changed?

The fuel filter in a Nissan 240SX should be changed every 10,000-15,000 miles, according to one source. However, another source suggests that it can be changed every 60,000 miles. Ultimately, it depends on various factors, such as the age of the car, the condition of the filter, and the driving conditions. It is recommended to inspect the fuel filter regularly and replace it when necessary.

To change the fuel filter in a Nissan 240SX, follow these steps:

  • Locate the fuel filter on the passenger side of the engine bay, attached to the strut tower about halfway down. It looks like a little silver can with one hose going into the top and one hose coming out of the bottom.
  • Take off the gas cap and remove the fuel pump fuse in the fuse box by your battery.
  • Crank the engine until it starts and then immediately dies.
  • Loosen the clamp on the top hose and slide it up on the tube, then tighten it slightly to prevent fuel leakage. Do the same for the lower hose. Be careful not to twist the hoses too much, as this can damage them and cause leaks.
  • Remove the old fuel filter by twisting it while holding the tubing. This will help loosen the connection.
  • Place a rag or towel underneath the filter to absorb any spilled fuel.
  • Install the new fuel filter and attach the hoses.
  • Re-tighten the clamps to secure the hoses.
  • If the tubing comes off easily, the whole process should take around 15-20 minutes.

shunfuel

What type of fuel filter should I use?

When it comes to choosing a fuel filter for your Nissan 240SX, there are a few options available on the market that will ensure a proper fit and efficient fuel filtration. Here are some recommendations and factors to consider:

  • OEM Fuel Filter: It is always a good option to go with the Original Equipment Manufacturer (OEM) fuel filter. This ensures that the filter is designed specifically for your Nissan 240SX and will fit perfectly. The OEM fuel filter for the Nissan 240SX is available online and at dealerships.
  • Aftermarket Fuel Filters: There are also several aftermarket fuel filters available that are designed to fit the Nissan 240SX. Some popular options include:
  • K&N High-Performance Fuel Filter PF-1100: This fuel filter is known for its high performance and is designed to fit the Nissan 240SX. It can be purchased from online retailers or automotive stores.
  • Fram Fuel Filter G4777: The Fram Fuel Filter is another popular option that is designed to fit the Nissan 240SX. It can be found at automotive stores or through online retailers.
  • Duralast Fuel Filter FF655DL: The Duralast Fuel Filter is also compatible with the Nissan 240SX and can be purchased online or at automotive stores.
  • Vehicle Specifications: It is important to consider the specific year and model of your Nissan 240SX when choosing a fuel filter. For example, the fuel filter for the 1989-1998 Nissan 240SX with a 2.4L engine may differ from newer models. Ensure that you are purchasing a fuel filter that is compatible with your vehicle's specifications.
  • Performance and Quality: When choosing a fuel filter, consider the quality and performance it offers. High-performance fuel filters can provide better filtration and fuel flow, which can result in improved engine performance and fuel efficiency. Look for fuel filters that are designed to meet or exceed OEM specifications.
  • Price and Reviews: Fuel filters can vary in price, so consider your budget when making a decision. Additionally, reading reviews from other Nissan 240SX owners can provide valuable insights into the quality, performance, and ease of installation for specific fuel filters.

In summary, when choosing a fuel filter for your Nissan 240SX, consider OEM options or reputable aftermarket brands that offer high-performance and quality filtration. Ensure that the fuel filter is compatible with your vehicle's specifications and always follow the manufacturer's instructions for proper installation.

Frequently asked questions

It is recommended to change the fuel filter in your 240SX every 10,000-15,000 miles.

The fuel filter is located on the passenger side of the engine bay, attached to the strut tower about halfway down.

It looks like a small silver canister with one black hose going into the top and one black hose coming out of the bottom.

First, relieve the fuel pressure by removing the gas cap and taking out the fuel pump fuse. Then, crank the engine—it should start then immediately die. Loosen the clamp on the top hose, slide the clamp up on the tube, and tighten it to squeeze the tube shut. Do the same for the lower tube. Be careful, as the tubes may be tough to get off. Once the tubes are off, some gas will spill out, so have a rag or towel ready to absorb it. Then, put the new filter in and attach the hoses. Re-tighten the clamps to their original positions.

You can buy a fuel filter for your 240SX from a Nissan dealer, an auto parts store, or online.

Written by
Reviewed by
Share this post
Print
Did this article help you?

Leave a comment