Changing Fuel Filter In 2005 Dodge Neon: Step-By-Step Guide

If you want to change the fuel filter on a 2005 Dodge Neon, you'll first need to locate it. The fuel filter is part of the fuel pump module, which is located inside the fuel tank. You'll need to raise the vehicle on a hoist to access it. Before starting, ensure you release the fuel system pressure as it is constantly under pressure, even when the engine is off. You can refer to the Fuel System Pressure Release in the Fuel Delivery System section for guidance on this. Once you've accessed the fuel pump module, you can disconnect the fuel supply line and replace the fuel filter. It is recommended to lightly lubricate the O-rings with engine oil before installing the new filter.

The fuel filter is located on the top of the fuel pump module

To change the fuel filter on a 2005 Dodge Neon, you must first locate the fuel pump module, as the filter is part of this assembly. The fuel pump module is located inside the fuel tank, beneath the trunk area, on the top of the fuel tank.

Before servicing the fuel filter, it is important to release the fuel system pressure, as it is under constant pressure, even when the engine is off.

To access the fuel pump module and fuel filter, you will need to raise the vehicle on a hoist. Once the vehicle is securely raised, you can disconnect the fuel supply line at the filter nipple. Depress the locking spring tab on the side of the filter and rotate it 90 degrees counter-clockwise to pull it out. Ensure that the upper and lower O-rings are present on the filter assembly.

When installing the new fuel filter, lightly lubricate the O-rings with engine oil. Insert the filter into the opening in the fuel pump module, aligning the hold-down tabs with the flange. Apply downward pressure while rotating the filter clockwise until the spring tab engages the locating slot. Finally, connect the fuel line to the filter and lower the vehicle from the hoist.

It is important to note that the fuel pump module does not need to be removed to replace the fuel filter. Additionally, always exercise caution when working with fuel systems to prevent injuries or accidents.

The fuel system must be depressurised before servicing the fuel filter

To release the pressure, refer to the Fuel System Pressure Release section in the Fuel Delivery System section of your user manual. Once the pressure is released, you can access the fuel filter/fuel pressure regulator, which is located on top of the fuel pump module.

• Raise the vehicle on a hoist.
• Disconnect the fuel supply line at the Filter/Regulator nipple.
• Depress the locking spring tab on the side of the Filter/Regulator and rotate it 90 degrees counter-clockwise, then pull it out. Ensure that the upper and lower O-rings are on the Filter/Regulator assembly.
• Lightly lubricate the O-rings with engine oil.
• Insert the new Filter/Regulator into the opening in the fuel pump module, aligning the two hold-down tabs with the flange.
• While applying downward pressure, rotate the Filter/Regulator clockwise until the spring tab engages the locating slot.
• Connect the fuel line to the Filter/Regulator.
• Lower the vehicle from the hoist.

Lubricate the O-rings with engine oil

Lubricating the O-rings with engine oil is an important step when changing the fuel filter on a 2005 Dodge Neon. Here is a detailed, step-by-step guide on how to do this:

Before lubricating the O-rings, make sure you have located the fuel filter. In the 2005 Dodge Neon, the fuel filter is part of the fuel pump module and is located on top of the fuel tank. It is integrated with the fuel pressure regulator, which is usually not the problem when it comes to fuel delivery issues.

Now, to lubricate the O-rings:

• Lightly coat the O-rings with engine oil. It is important to only use a small amount of oil and not to overdo it.
• Make sure that both the upper and lower O-rings are coated. There should be two O-rings in the Filter/Regulator assembly.
• Wipe off any excess oil. You don't want any oil dripping everywhere or getting onto other components.
• Proceed with the installation of the new fuel filter. Insert the Filter/Regulator into the opening in the fuel pump module, aligning the tabs with the flange.
• Apply downward pressure and rotate the Filter/Regulator clockwise until it locks into place. You will feel it engage and you may hear a slight click.
• Connect the fuel line to the Filter/Regulator.
• Lower the vehicle if it was raised during the process.

Remember, it is important to only use engine oil to lubricate the O-rings. This will ensure a proper seal and help prevent leaks. Do not overtighten any connections and always refer to a professional mechanic if you are unsure about any steps or procedures.

The fuel filter is part of the fuel pump assembly

To change the fuel filter on a 2005 Dodge Neon, you must first locate the fuel pump module. The fuel filter is part of the fuel pump assembly, and you will find it on top of the fuel pump module.

Before servicing the fuel filter, you must release the fuel system pressure. The fuel system is under constant pressure, even when the engine is off.

• Raise the vehicle on a hoist.
• Disconnect the fuel supply line at the Filter/Regulator nipple (refer to Quick Connect Fittings).
• Depress the locking spring tab on the side of the Fuel/Regulator and rotate it 90 degrees counter-clockwise, then pull it out. Ensure that the upper and lower O-rings are on the Filter/Regulator assembly.
• Lightly lubricate the O-rings with engine oil.
• Insert the Filter/Regulator into the opening in the fuel pump module. Align the two hold-down tabs with the flange.
• Apply downward pressure and rotate the Filter/Regulator clockwise until the spring tab engages the locating slot.
• Connect the fuel line to the Filter/Regulator.
• Lower the vehicle from the hoist.

It is important to note that not all Dodge Neon models have a fuel filter. For example, the 1999 Neon R/T only has a sock on the pump.

The fuel filter is located under the trunk area, on top of the fuel tank

To change the fuel filter on a 2005 Dodge Neon, you'll first need to locate it. The fuel filter is situated under the trunk area, on top of the fuel tank. It's important to note that the fuel system is under constant pressure, even when the engine is off. Therefore, before servicing the fuel filter, you must release the fuel system pressure.

• Refer to the Fuel System Pressure Release instructions in the Fuel Delivery System section.
• Disconnect the fuel supply line at the Filter/Regulator nipple.
• Depress the locking spring tab on the side of the Filter/Regulator and rotate it 90 degrees counter-clockwise, then pull it out. Ensure that the upper and lower O-rings are on the Filter/Regulator assembly.
• Lightly lubricate the O-rings with engine oil.
• Insert the new Filter/Regulator into the opening in the fuel pump module, aligning the two hold-down tabs with the flange.
• While applying downward pressure, rotate the Filter/Regulator clockwise until the spring tab engages the locating slot.
• Connect the fuel line to the Filter/Regulator.

It is recommended to refer to a mechanic or a professional if you have doubts or feel uncomfortable working on your vehicle.

Frequently asked questions